cd /tmp sudo apt-get install -y libjpeg62 libjpeg62-dev libavformat53 libavformat-dev libavcodec53 libavcodec-dev libavutil51 libavutil-dev libc6-dev zlib1g-dev libmysqlclient18 libmysqlclient-dev libpq5 libpq-dev wget https:// Note: in the standard motion installation, the is in /etc/motion/, but in the special motion-mmal build from dropbox-url (see above) it's in /etc/.
If you follow this tutorial with all steps, this is no problem at all.
For Windows, you will need the extra (free) software Pu TTY.
The Raspberry should boot up and guide you through the setup process as explained in this Adafruit tutorial.
After this, you should have a basic Raspbian OS running.
This is very important as once mounted far away from your desktop, you need to be able to make updates and change the configuration of this camera any time later without the need to detaching it from the wall and bringing it back to your desk.
Remember that this cam is not just a dump cam device but a very powerful computer with Linux OS running on it.
Be sure to enable SSH in Raspbian so that you are able to control the Raspberry device also when there is no monitor and keyboard attached.